Check For Faults (Show Faulty Command) - Sun Oracle SPARC T3-1B Service Manual

▼ Check for Faults (show faulty Command)

Use the Oracle ILOM show faulty command to display the following kinds of
faults and alerts:
Environmental or configuration faults – Faults caused by temperature or voltage
■
problems. Environmental faults can also be caused by room temperature or
blocked air flow.
POST-detected faults – Faults on devices detected by the POST diagnostics.
■
PSH-detected faults – Faults detected by the Oracle Solaris PSH technology.
■
1. At the -> prompt, enter the show faulty command.
2. If a fault is displayed, check the output to determine the nature of the fault.
The following examples show the different kinds of output that might be
displayed:
■
-> show faulty
Target
--------------------+------------------------+-------------------
-----------------------------------------------------------------
->
■
-> show faulty
Target
--------------------+------------------------+-------------------------------
/SP/faultmgmt/0
/SP/faultmgmt/0
faults/0
/SP/faultmgmt/0
faults/0
/SP/faultmgmt/0
faults/0
/SP/faultmgmt/0
faults/0
/SP/faultmgmt/0
faults/0
/SP/faultmgmt/0
faults/0
18 SPARC T3-1B Server Module Service Manual • July 2012
Example of the show faulty command when no faults are present:
Example of the show faulty command displaying a fault when one of the AC
inputs for power supply PS0 is not plugged in:
| Property
| fru
| class
|
| sunw-msg-id
|
| uuid
|
| timestamp
|
| detector
|
| product_serial_number
|
| Property
| Value
| /SYS/PS0
| fault.chassis.env.power.loss
|
| SPT-8000-5X
|
| 64d52ce4-614e-693f-bb71-ea3f829d
| ad73
| 2010-10-14/20:14:13
|
| /SYS/PS0/S1/V_IN_ERR
|
| 1030NND0D2
|
| Value