Measurement View; Setting The Location And Fuel; Flue Gas - TESTO 320 Instruction Manual

6.2.1.4.
6.2.1.5.
6.2.2.
info@Testo-Direct.com
All manuals and user guides at all-guides.com

Measurement view

Only those measurement parameters and -units that are enabled in
the reading display appear in the reading display, in the saved
measurement records and on record printouts.
> Before carrying out measurements, set up the measured value
display in such a way that the required parameters and units
are enabled, see Measurement view, page 34.

Setting the location and fuel

Before carrying out measurements, the location and fuel must be
correctly selected, see Address/Location, page 30 and see Fuels,
page 42.

Flue gas

To achieve usable measurement results, the measurement
period of a flue gas measurement should be approx. 3 min
and the measuring instrument should display stable
measuring values.
Call up function:
1. [ ] → Measurement options
2. Select the fuel → [OK].
Carrying out the measurement:
1. Start measurement:
If a separate measurement of CO undiluted has not yet
been carried out, this value is calculated using the
measured values of the flue gas probe and is updated
continuously.
If CO undiluted and/or a draught measurement has already
been carried out separately, the value obtained is applied.
- The measured values are displayed.
2. End measurement:
Options
> [Options] → Clipboard: data is saved to the clipboard.
[Options] Delete
> →
is deleted.
> [Options] → Save: the measured values are saved in a record.
[Options] Fluegas
> →
displayed as a flue gas matrix, see below.
www.
→ [OK] →
[ ].
[ ].
clipboard: any data saved to the clipboard
matrix: the measured values are
Testo-Direct
6 Using the product
Flue Gas → [OK].
45
1.888.610.7664
.com