Yamaha FJR13AEV(C) Service Manual page 702

b. Move the fuel sender float to minimum "3"
and maximum "4" level position.
c. Measure the fuel sender resistance.
L LLL L LLL L L LLL L L LLL L
EAS28250
CHECKING THE RADIATOR FAN MOTORS
The following procedure applies to both of the
radiator fan motors.
1. Check:
• Radiator fan motor
Faulty/rough movement → Replace.
M MMM M MMM M M MMM M M MMM M
a. Disconnect the radiator fan motor coupler
from the wire harness.
b. Connect the battery (DC 12 V) as shown.
• Positive battery terminal →
blue "1"
• Negative battery terminal →
black "2"
c. Measure the radiator fan motor movement.
L LLL L LLL L L LLL L L LLL L
3
L LLL L L LLL L LLL
M MMM M M MMM M MMM
L LLL L L LLL L LLL
8-231
ELECTRICAL COMPONENTS
EAS28260
CHECKING THE COOLANT TEMPERATURE
SENSOR
1. Remove:
• Coolant temperature sensor
EWA14130
WARNING
• Handle the coolant temperature sensor
with special care.
• Never subject the coolant temperature sen-
sor to strong shocks. If the coolant temper-
ature sensor is dropped, replace it.
2. Check:
• Coolant temperature sensor resistance
Out of specification → Replace.
Coolant temperature sensor re-
sistance
290–354 Ω at 80 °C (176 °F)
M MMM M MMM M M MMM M M MMM M
a. Connect the pocket tester (Ω × 100) to the
coolant temperature sensor terminals as
shown.
Pocket tester
90890-03112
Analog pocket tester
YU-03112-C
3
1
b. Immerse the coolant temperature sensor "1"
in a container filled with coolant "2".
NOTE:
Make sure that the coolant temperature sensor
terminals do not get wet.
c. Place a thermometer "3" in the coolant.
d. Slowly heat the coolant, and then let it cool
down to the specified temperature.
e. Measure the coolant temperature sensor re-
sistance.
L LLL L LLL L L LLL L L LLL L
3. Install:
• Coolant temperature sensor
M MMM M M MMM M MMM
2
L LLL L L LLL L LLL