Front tire
Size
120/70 ZR17M/C (58W)
Manufacturer/model
METZELER/Roadtec Z6G
Manufacturer/model
BRIDGESTONE/BT020F
Rear tire
Size
180/55 ZR17M/C (73W)
Manufacturer/model
METZELER/Roadtec Z6C
Manufacturer/model
BRIDGESTONE/BT020R
EWA13210
WARNING
New tires have a relatively low grip on the
road surface until they have been slightly
worn. Therefore, approximately 100 km
should be traveled at normal speed before
any high-speed riding is done.
NOTE:
For tires with a direction of rotation mark "1":
Install the tire with the mark pointing in the direc-
tion of wheel rotation.
EAS21670
CHECKING THE WHEELS
The following procedure applies to both of the
wheels.
1. Check:
• Wheel
Damage/out-of-round → Replace.
EWA13260
WARNING
Never attempt to make any repairs to the
wheel.
NOTE:
After a tire or wheel has been changed or re-
placed, always balance the wheel.
EAS21690
CHECKING AND LUBRICATING THE
CABLES
The following procedure applies to all of the in-
ner and outer cables.
EWA13270
WARNING
Damaged outer cable may cause the cable to
corrode and interfere with its movement. Re-
place damaged outer cable and inner cables
as soon as possible.
1. Check:
• Outer cable
Damage → Replace.
2. Check:
• Cable operation
Rough movement → Lubricate.
Recommended lubricant
Engine oil or a suitable cable lu-
bricant
NOTE:
Hold the cable end upright and pour a few drops
of lubricant into the cable sheath or use a suit-
able lubricating device.
EAS21700
LUBRICATING THE LEVERS
Lubricate the pivoting point and metal-to-metal
moving parts of the levers.
Recommended lubricant
Lithium-soap-based grease
EAS21710
LUBRICATING THE PEDALS
Lubricate the pivoting point and metal-to-metal
moving parts of the pedals.
Recommended lubricant
Lithium-soap-based grease
EAS21720
LUBRICATING THE SIDESTAND
Lubricate the pivoting point and metal-to-metal
moving parts of the sidestand.
Recommended lubricant
Lithium-soap-based grease
EAS21730
LUBRICATING THE CENTERSTAND
Lubricate the pivoting point and metal-to-metal
moving parts of the centerstand.
3-42
CHASSIS