Table of Contents
Advertisement
1. Auxiliary DC jack
2. Left radiator fan motor lead
3. Accessory box solenoid
4. Wire harness
5. Front cowling wire harness
6. Radiator inlet hose
7. Left radiator fan
8. Coolant reservoir breather hose
9. Left horn (low)
10. Left horn (low) leads
11. Thermostat assembly breather hose
12. Joint coupler
A. Fasten the handlebar switch leads to the front
cowling wire harness with a plastic locking tie.
Face the end of the plastic locking tie rearward,
along the side of the accessory box. Do not cut off
the excess end of the plastic locking tie.
B. Fasten the wire harness and left radiator fan motor
lead with the holder.
C. Fasten the front cowling wire harness to the
radiator inlet hose with a plastic locking tie, making
sure to install the tie on the harness' protective
sleeve, and then cut off the excess end of the tie.
D. After connecting the couplers, cover them
completely with the cover, and then push them in
between the radiator inlet hose and the thermostat
inlet hose 2.
CABLE ROUTING (FJR13A)
2-54
Advertisement
Chapters
Table of Contents
Troubleshooting
