Adjusting The Foot Shift Switch - Yamaha FJR13AEV(C) Service Manual

SHIFT ACTUATOR AND SHIFT ROD (FJR13AE only)
Shift pedal pivot bolt
16 Nm (1.6 m·kg, 11 ft·lb)
®
LOCTITE
NOTE:
• Position the projection "a" on the shift pedal be-
tween the ends "b" of the spring on the left foot-
rest assembly.
• Be sure to fit the projections "c" on the shift
pedal pivot into the holes "d" in the left footrest
assembly.
5
6
7
c
a
3 2
1
4
b
3. Install:
• Holder "1"
• Foot shift switch "2"
NOTE:
• Be sure to align the cutouts "a" in the holder
with the projections "b" on the shift pedal pivot.
• Fit the foot shift switch onto the holder, and
then rotate the sensor counterclockwise and
temporarily install the screws. Be sure to fit the
section "c" of the holder into the opening "d"
shown in the illustration.
b
2
b
d
d
b
1
a
c
a
5-70
4. Adjust:
• Foot shift switch
Refer to "ADJUSTING THE FOOT SHIFT
SWITCH" on page 5-70.
ET3P66040

ADJUSTING THE FOOT SHIFT SWITCH

1. Check:
• Foot shift switch
Refer to "CHECKING THE FOOT SHIFT
SWITCH (FJR13AE only)" on page 8-235.
2. Adjust:
• Foot shift switch angle
M MMM M MMM M M MMM M M MMM M
a. Connect the foot shift switch coupler to the
foot shift switch.
b. Connect the digital circuit tester to the foot
shift switch coupler.
• Positive tester probe →
orange "1"
• Negative tester probe →
black "2"
Digital circuit tester
90890-03174
Model 88 Multimeter with ta-
chometer
YU-A1927
c. Turn the main switch to "ON".
d. Measure the foot shift switch voltage.
e. Adjust the foot shift switch angle so that the
voltage is within the specified range.
Output voltage
FJR13AE 2.4–2.6 V
f. After adjusting the foot shift switch angle,
tighten the foot shift switch screws "3" to
specification.
Foot shift switch screw
4 Nm (0.4 m·kg, 2.9 ft·lb)
®
LOCTITE
M MMM M M MMM M MMM