Yamaha FJR13AEV(C) Service Manual page 706

ET3P66021
CHECKING THE GEAR POSITION SENSOR
(FJR13AE only)
1. Remove:
• Gear position sensor
NOTE:
Remove only the screws "1" when removing the
gear position sensor. Do not remove the screws
"2".
2
2. Check:
• Gear position sensor maximum resistance
Out of specification → Replace the gear posi-
tion sensor.
Resistance
FJR13AE 4.0–6.0 kΩ
M MMM M MMM M M MMM M M MMM M
a. Connect the pocket tester (Ω × 1k) to the gear
position sensor terminals as shown.
Pocket tester
90890-03112
Analog pocket tester
YU-03112-C
• Positive tester probe →
blue "1"
• Negative tester probe →
black/blue "2"
1
L Y B/L
b. Measure the gear position sensor maximum
resistance.
L LLL L LLL L L LLL L L LLL L
1
2
1
M MMM M M MMM M MMM
2
L LLL L L LLL L LLL
8-235
ELECTRICAL COMPONENTS
3. Install:
• Gear position sensor
Refer to "INSTALLING THE GEAR POSI-
TION SENSOR (FJR13AE only)" on page
5-11.
ET3P66022
CHECKING THE FOOT SHIFT SWITCH
(FJR13AE only)
1. Remove:
• Foot shift switch
2. Check:
• Foot shift switch maximum resistance
Out of specification → Replace the foot shift
switch.
Resistance
FJR13AE 4.0–6.0 kΩ
M MMM M MMM M M MMM M M MMM M
a. Connect the pocket tester (Ω × 1k) to the foot
shift switch terminals as shown.
Pocket tester
90890-03112
Analog pocket tester
YU-03112-C
• Positive tester probe →
blue "1"
• Negative tester probe →
black "2"
2
B O
b. Measure the foot shift switch maximum resis-
tance.
L LLL L LLL L L LLL L L LLL L
3. Install:
• Foot shift switch
Refer to "INSTALLING THE FOOT SHIFT
SWITCH" on page 5-69.
ET3P66023
CHECKING THE GRIP WARMERS (FJR13AE
only)
The following procedure applies to both of the
grip warmers.
M MMM M M MMM M MMM
1
L
L LLL L L LLL L LLL