Installing The Drive Shaft And Final Drive Assembly (Fjr13Ae) - Yamaha FJR13AEV(C) Service Manual

11.Check:
• Shift pedal position
Refer to "ADJUSTING THE SHIFT PEDAL
(FJR13A)" on page 3-32.
ET3P66032
INSTALLING THE DRIVE SHAFT AND FINAL
DRIVE ASSEMBLY (FJR13AE)
1. Lubricate:
• Drive shaft spline (final drive pinion gear side)
Recommended lubricant
Molybdenum disulfide grease
2. Lubricate:
• Drive shaft spline (universal joint side)
Recommended lubricant
Lithium-soap-based grease
3. Install:
New
• Oil seal "1"
• Washer "2"
(with the fork seal driver weight "3" and fork
seal driver attachment "4")
Fork seal driver weight
90890-01184
Replacement hammer
YM-A9409-7
Fork seal driver attachment
90890-01186
Replacement 27 mm
YM-A9409-1
4. Install:
• Circlip New
5. Install:
• Drive shaft "1"
(to the final drive pinion gear)
• Oil seal "2"
(to the final gear case with the fork seal driver
weight "3" and oil seal installing tool "4")
6. Install:
NOTE:
Align the drive shaft splines with the driven yoke
of the universal joint.
3
7. Tighten:
4
2
1 New
8. Install:
9. Install:
4-109
Fork seal driver weight
90890-01184
Replacement hammer
YM-A9409-7
Oil seal installing tool
90890-01512
YM-01512
Installed depth "a"
8.5–10.0 mm (0.33–0.39 in)
3
• Universal joint
• Final drive assembly
• Final drive assembly nuts
Final gear case nut
42 Nm (4.2 m·kg, 30 ft·lb)
• Sidestand
• Left footrest assembly
Refer to "SHIFT ACTUATOR AND SHIFT
ROD (FJR13AE only)" on page 5-67.
• Rear wheel
Refer to "REAR WHEEL" on page 4-24.
SHAFT DRIVE
1
4
2
a