Yamaha FJR13AEV(C) Service Manual page 492

EAS27180
STARTING CIRCUIT CUT-OFF SYSTEM OPERATION (FJR13A)
If the engine stop switch is set to "
closed), the starter motor can only operate if at least one of the following conditions is met:
• The transmission is in neutral (the neutral circuit of the gear position switch is closed).
• The clutch lever is pulled to the handlebar (the clutch switch circuit is closed) and the sidestand is up
(the sidestand switch circuit is closed).
The starting circuit cut-off relay prevents the starter motor from operating when neither of these condi-
tions has been met. In this instance, the starting circuit cut-off relay stays open so current cannot reach
the starter motor. When at least one of the above conditions has been met, the starting circuit cut-off
relay is closed and the engine can be started by pushing the start switch " ".
a. WHEN THE TRANSMISSION IS IN
NEUTRAL
b. WHEN THE SIDESTAND IS UP AND THE
CLUTCH LEVER IS PULLED TO THE
HANDLEBAR
1. Battery
2. Main fuse
3. Main switch
4. Ignition fuse
5. Engine stop switch
6. Starting circuit cut-off relay
7. Relay unit (diode)
ELECTRIC STARTING SYSTEM
" and the main switch is turned "ON" (both switch circuits are
13
12
1
2
3
4
5
6
7
7
a
8
7
10
9
b
8. Clutch switch
9. Sidestand switch
10. Gear position switch
11. Start switch
12. Starter relay
13. Starter motor
8-21
11