Yamaha FJR13AEV(C) Service Manual page 210

M MMM M MMM M M MMM M M MMM M
a. Insert the front wheel axle from the right side
and tighten it with the front wheel axle bolt
from the left side to 91 Nm (9.1 m·kg, 66 ft·lb).
b. In the order pinch bolt "2" → pinch bolt "1" →
pinch bolt "2", tighten each bolt to 21 Nm (2.1
m·kg, 15 ft·lb) without performing temporary
tightening.
c. Check that the right end of the front wheel
axle is flush with the front fork. If necessary,
manually push the front wheel axle or lightly
tap it with a soft hammer until its end is flush
with the front fork. However, if the surface of
the front wheel axle end is not parallel to the
surface of the front fork, align a point on the
outer edge of the axle with the fork, making
sure that the axle does not protrude past the
fork.
d. In the order pinch bolt "4" → pinch bolt "3" →
pinch bolt "4", tighten each bolt to 21 Nm (2.1
m·kg, 15 ft·lb) without performing temporary
tightening.
4 3
L LLL L LLL L L LLL L L LLL L
6. Install:
• Front brake calipers
• Front wheel sensor
Front brake caliper bolt
40 Nm (4.0 m·kg, 29 ft·lb)
Front wheel sensor bolt
30 Nm (3.0 m·kg, 22 ft·lb)
NOTE:
When installing the front wheel sensor, check
the wheel sensor lead for twists and the sensor
electrode for foreign materials.
EC3P66003
CAUTION:
• Make sure there are no foreign materials in
the wheel hub. Foreign materials cause
damage to the inner sensor rotor and wheel
sensor.
M MMM M M MMM M MMM
2 1
L LLL L L LLL L LLL
4-23
FRONT WHEEL
• To route the front wheel sensor lead, refer
to "CABLE ROUTING (FJR13A)" on page
2-47 and "CABLE ROUTING (FJR13AE)" on
page 2-67.
EWA13500
WARNING
Make sure the brake hose is routed properly.
7. Check:
• Front wheel sensor installation
Check if the wheel sensor housing is installed
properly.
8. Install:
• Front fender
NOTE:
When installing the front fender, make sure that
there is no dirt between the front fender and front
fork legs.