Installing The Drive Shaft And Final Drive Assembly (Fjr13A) - Yamaha FJR13AEV(C) Service Manual

EAS23660
INSTALLING THE DRIVE SHAFT AND FINAL
DRIVE ASSEMBLY (FJR13A)
1. Lubricate:
• Drive shaft spline (final drive pinion gear side)
Recommended lubricant
Molybdenum disulfide grease
2. Lubricate:
• Drive shaft spline (universal joint side)
Recommended lubricant
Lithium-soap-based grease
3. Install:
• Oil seal "1" New
• Washer "2"
(with the fork seal driver weight "3" and fork
seal driver attachment "4")
Fork seal driver weight
90890-01184
Replacement hammer
YM-A9409-7
Fork seal driver attachment
90890-01186
Replacement 27 mm
YM-A9409-1
4. Install:
New
• Circlip
5. Install:
• Universal joint
• Final drive assembly
NOTE:
Align the drive shaft splines with the driven yoke
of the universal joint.
6. Tighten:
• Final drive assembly nuts
Final gear case nut
42 Nm (4.2 m·kg, 30 ft·lb)
7. Install:
NOTE:
Install the left footrest assembly/sidestand bolts
"1", left footrest assembly bolts (M8) "2" and left
footrest assembly bolt (M10) "3" temporarily and
then tighten them to the specified torques in the
proper tightening sequence as shown.
8. Install:
NOTE:
Align the punch mark "a" in the shift shaft with
the slot in the shift arm.
3
4
2
New
1
9. Install:
10.Fill:
4-108
• Sidestand
• Left footrest assembly
Left footrest assembly/sidestand
bolt
65 Nm (6.5 m·kg, 47 ft·lb)
Left footrest assembly bolt (M8)
28 Nm (2.8 m·kg, 20 ft·lb)
Left footrest assembly bolt (M10)
49 Nm (4.9 m·kg, 35 ft·lb)
2
3
• Shift arm "1"
• Rear wheel
Refer to "REAR WHEEL" on page 4-24.
• Final gear case
Refer to "CHECKING THE FINAL GEAR OIL
LEVEL" on page 3-33.
SHAFT DRIVE
1