Yamaha FJR13AEV(C) Service Manual page 131

1. Clutch actuator motor lead
2. Clutch actuator sensor lead
3. License plate light lead
4. Tail/brake light assembly lead
5. Seat lock cable
6. Intake air temperature sensor
A. Connect the clutch actuator motor lead and clutch
actuator sensor lead, install the rubber cover
around the leads, and then place the cover
between the hydraulic unit and the frame. When
closing the rubber cover, make sure that the thick
section at the base of each projection (four
locations) on one side of the cover is pulled
through its corresponding hole on the other side.
Face the side of the rubber cover with the
projections outward.
B. Fasten the clutch actuator motor lead and clutch
actuator sensor lead with the band that is used to
secure the MCU (motor control unit).
C. Make sure that the projection on the storage
compartment fits into the indentation in the MCU
(motor control unit). The MCU should not be
resting on top of the projection.
D. Route the tail/brake light assembly lead and
license plate light lead between the rib and the U-
lock holder on the rear fender, making sure that the
leads are not routed on top of the holder.
E. Fasten the tail/brake light assembly lead and
license plate light lead with the holder.
F. Route the tail/brake light assembly lead and
license plate light lead between the ribs on the rear
fender.
G. To shift actuator
H. Route the intake air temperature sensor lead
under the wire harness.
I. Fasten the intake air temperature sensor lead to
the air filter case with the holder.
CABLE ROUTING (FJR13AE)
2-82