Adjusting The Rear Wheel Static Balance; Installing The Rear Wheel (Rear Brake Disc) - Yamaha FJR13AEV(C) Service Manual

1
2. Rear wheel
2. Install:
• Wheel bearings New
• Oil seals New
Refer to "ASSEMBLING THE FRONT
WHEEL" on page 4-21.
EAS22150
ADJUSTING THE REAR WHEEL STATIC
BALANCE
NOTE:
• After replacing the tire, wheel, or both, the rear
wheel static balance should be adjusted.
• Adjust the rear wheel static balance with the
brake disc and rear wheel drive hub installed.
1. Adjust:
• Rear wheel static balance
Refer to "ADJUSTING THE FRONT WHEEL
STATIC BALANCE" on page 4-21.
EAS22170
INSTALLING THE REAR WHEEL (REAR
BRAKE DISC)
1. Install:
• Rear brake disc
Rear brake disc bolt
18 Nm (1.8 m·kg, 13 ft·lb)
®
LOCTITE
NOTE:
Tighten the brake disc bolts in stages and in a
crisscross pattern.
a
2
2. Check:
3. Lubricate:
4. Install:
NOTE:
• Align the slot "a" of the rear wheel sensor hous-
• After assembling the rear wheel sensor hous-
ECA14470
Make sure there are no foreign materials in
the wheel hub. Foreign materials cause dam-
age to the inner sensor rotor and wheel sen-
sor.
EWA13500
Make sure the brake hose is routed properly.
4-27
• Rear brake disc
Refer to "CHECKING THE REAR BRAKE
DISC" on page 4-47.
• Oil seal lips
Recommended lubricant
Lithium-soap-based grease
• Rear wheel sensor housing
• Rear wheel
• Rear brake caliper
• Rear wheel axle
• Brake torque rod
• Rear wheel axle nut
ing "1" with the projection "b" of the rear brake
caliper bracket "2", and then assemble them.
ing and the rear brake caliper bracket, make
sure that the projection "c" on the housing is
aligned with the projection "d" on the bracket.
CAUTION:
WARNING
REAR WHEEL