Installing The Gear Position Sensor (Fjr13Ae Only); Adjusting The Gear Position Sensor (Fjr13Ae Only) - Yamaha FJR13AEV(C) Service Manual

ET3P66035
INSTALLING THE GEAR POSITION SENSOR
(FJR13AE only)
1. Connect:
• MCU coupler
• ECU coupler
Refer to "GENERAL CHASSIS" on page 4-1.
2. Install:
• Gear position sensor "1"
EC3P66001
CAUTION:
Shift the transmission into neutral before in-
stalling the gear position sensor, otherwise
the sensor may be damaged.
NOTE:
Fit the end "a" of the shift drum assembly into the
opening "b" in the gear position sensor "1", and
then rotate the sensor counterclockwise and
temporarily install the screws.
a
3. Adjust:
• Gear position sensor
Refer to "ADJUSTING THE GEAR POSI-
TION SENSOR (FJR13AE only)" on page
5-11.
ET3P66036
ADJUSTING THE GEAR POSITION SENSOR
(FJR13AE only)
1. Check:
• Gear position sensor
Refer to "CHECKING THE GEAR POSITION
SENSOR (FJR13AE only)" on page 8-235.
2. Adjust:
• Gear position sensor angle
M MMM M MMM M
a. Connect the gear position sensor coupler to
the gear position sensor.
b. Connect the digital circuit tester to the gear
position sensor.
• Positive tester probe →
yellow "1"
• Negative tester probe →
black/blue "2"
c. Turn the main switch to "ON".
d. Measure the gear position sensor voltage.
e. Adjust the gear position sensor angle so that
1
the voltage is within the specified range.
f. After adjusting the gear position sensor an-
gle, tighten the gear position sensor screws
b
"3" to specification.
L LLL L LLL L
3. Check:
• Gear position setting
Refer to "Diagnostic code table (Diagnostic
code No. Sh_ _65)".
5-11
ENGINE REMOVAL
M MMM M M MMM M M MMM M
Digital circuit tester
90890-03174
Model 88 Multimeter with ta-
chometer
YU-A1927
Output voltage (at neutral posi-
tion)
FJR13AE 0.71–0.91 V
Gear position sensor screw
4 Nm (0.4 m·kg, 2.9 ft·lb)
®
LOCTITE
1
L LLL L L LLL L L LLL L
M MMM M MMM
3
2
L LLL L LLL