Yamaha FJR13AEV(C) Service Manual page 695

2
W/B
/B
R
R /L
L LLL L LLL L L LLL L L LLL L
3. Check:
• ABS motor relay continuity
No continuity → Replace.
M MMM M MMM M M MMM M M MMM M
a. Connect the pocket tester (Ω × 1) to the ABS
motor relay terminal as shown.
Pocket tester
90890-03112
Analog pocket tester
YU-03112-C
3
4
2
1
W/B R/W
R/B
R/L
1. Positive battery terminal
2. Negative battery terminal
3. Positive tester probe
4. Negative tester probe
L LLL L LLL L L LLL L L LLL L
ET3P61014
CHECKING THE TURN SIGNAL/HAZARD
RELAY
1. Check:
• Turn signal/hazard relay input voltage
Out of specification → The wiring circuit from
the main switch to the turn signal/hazard re-
lay coupler is faulty and must be repaired.
Turn signal/hazard relay input
voltage
DC 12 V
M MMM M MMM M M MMM M M MMM M
a. Connect the pocket tester (DC 20 V) to the
turn signal/hazard relay terminal as shown.
1
R/W R/W R/W
L LLL L L LLL L LLL
M MMM M M MMM M MMM
+
L LLL L L LLL L LLL
M MMM M M MMM M MMM
8-224
ELECTRICAL COMPONENTS
Pocket tester
90890-03112
Analog pocket tester
YU-03112-C
• Positive tester probe →
blue/red "1"
• Negative tester probe →
ground
b. Turn the main switch to "ON".
c. Measure the turn signal/hazard relay input
voltage.
L LLL L LLL L L LLL L L LLL L
2. Check:
• Turn signal/hazard relay output voltage
Out of specification → Replace.
Turn signal/hazard relay output
voltage
DC 12 V
M MMM M MMM M M MMM M M MMM M
a. Connect the pocket tester (DC 20 V) to the
turn signal/hazard relay terminal as shown.
Pocket tester
90890-03112
Analog pocket tester
YU-03112-C
• Positive tester probe →
brown/green "1"
• Negative tester probe →
ground
L LLL L L LLL L LLL
M MMM M M MMM M MMM