Yamaha FJR13AEV(C) Service Manual page 127

1. Wire harness
2. ECU (engine control unit)
3. ABS ECU (electronic control unit)
4. MCU (motor control unit)
5. Tail/brake light
6. Rear turn signal light
7. Tail/brake light assembly lead
8. License plate light lead
9. Seat lock cable
10. Shift actuator motor lead
11. ABS wire harness
12. Foot shift switch lead
13. Clutch fluid reservoir hose
14. Shift actuator sensor lead
15. Hydraulic unit breather hose
16. Stator coil lead
17. Rear shock absorber spring preload adjusting
cable
18. Rectifier/regulator
19. Rectifier/regulator lead
20. Brake hose (hydraulic unit to metering valve)
21. Hydraulic unit
22. Rear wheel sensor lead
23. Rear brake light switch lead
24. Brake hose (front brake master cylinder to
hydraulic unit)
25. Brake hose (hydraulic unit to front brake calipers)
26. Brake hose (rear brake master cylinder to
hydraulic unit)
27. Brake hose (hydraulic unit to proportioning valve)
A. Pass the license plate light lead through the hole in
the rear fender.
B. Route the wire harness to the inside of the seat
lock cable.
C. Fasten the shift actuator motor lead, shift actuator
sensor lead, and foot shift switch lead to the ABS
wire harness with a plastic locking tie, making sure
to position the harness to the outside of the other
leads. Face the end of the plastic locking tie
inward, without cutting off the excess end.
D. Fasten the ABS wire harness with the holder.
E. Route the stator coil lead and rectifier/regulator
lead to the outside of the rear shock absorber
spring preload adjusting cable and under the
hydraulic unit breather hose and clutch fluid
reservoir hose.
F. Pass the stator coil lead, rectifier/regulator lead,
and hydraulic unit breather hose through the guide
on the frame, making sure to route the hose to the
outside of the leads.
G. Fasten the leads (to ABS wire harness and rear
brake light switch) that branch off from the wire
harness with the holder.
H. When installing the ABS ECU, be sure not to pinch
the rear wheel sensor lead and ABS wire harness
between the ABS ECU and the rear fender.
I. Route the rear right turn signal light lead under the
right tail/brake light bulb socket.
J. Route the tail/brake light assembly lead between
the left tail/brake light bulb socket and the
mounting boss on the tail/brake light assembly.
K. Route the rear right turn signal light lead and right
tail/brake light lead over the left tail/brake light bulb
socket.
CABLE ROUTING (FJR13AE)
L. Route the leads between the left tail/brake light
bulb socket and the rear left turn signal light bulb
socket.
M. Route the tail/brake light assembly lead between
the tail/brake light assembly and its bracket.
2-78