Yamaha FJR13AEV(C) Service Manual page 662

Hide thumbs Also See for FJR13AEV(C):
Table of Contents

Advertisement

YCC-S (Yamaha Chip Controlled-Shift) SYSTEM (FJR13AE only)
Fault code No.
Sh_ _27
Order Item/components and probable
cause
1
YCC-S test coupler
2
Short circuit in wire harness.
NOTE:
If the main switch is turned to "OFF", the fault code number will disappear from the display and will not
be displayed again when the main switch is turned back to "ON". Therefore, use the engine stop switch
to stop the engine, not the main switch. If the fault code number has disappeared, activate the diagnos-
tic mode and select diagnostic code No. Sh_ _61. The fault code numbers can be confirmed in the mal-
function history.
Fault code No.
Sh_ _31
Order Item/components and probable
cause
1
Connections
• Wire harness MCU (motor control
unit) coupler
• Wire harness ECU coupler
2
Open or short circuit in wire harness.
Symptom
Diagnosis mode is activated at engine start-up.
Check or maintenance job
• Check that the test coupler
adapter is not connected.
Refer to "DIAGNOSTIC MODE"
on page 8-175.
• Repair or replace if there is a
short circuit.
• Between YCC-S test coupler
and MCU (motor control unit)
coupler.
(blue/yellow–blue/yellow)
Symptom
Engine speed signal is abnormal.
Check or maintenance job
• Check the coupler for any pins
that may be pulled out.
• Check the locking condition of
the coupler.
• If there is a malfunction, repair it
and connect the coupler se-
curely.
• Repair or replace if there is an
open or short circuit.
• Between ECU coupler and
MCU (motor control unit) cou-
pler.
(yellow/black–yellow/black)
8-191
Reinstatement
method
Turning the
main switch to
"OFF".
See NOTE.
Reinstatement
method
Repairing the
cause of the
malfunction.

Advertisement

Table of Contents

Troubleshooting

loading

This manual is also suitable for:

Fjr13av(c)

Table of Contents