Assembling The Clutch Master Cylinder; Installing The Clutch Master Cylinder (Fjr13A) - Yamaha FJR13AEV(C) Service Manual

Hide thumbs Also See for FJR13AEV(C):
Table of Contents

Advertisement

Recommended clutch component replace-
ment schedule
Clutch fluid
1. Check:
• Clutch master cylinder body
Cracks/damage → Replace the clutch mas-
ter cylinder.
• Clutch fluid delivery passage
(clutch master cylinder body)
Obstruction → Blow out with compressed air.
2. Check:
• Clutch master cylinder
• Clutch master cylinder kit
Rust/scratches/wear → Replace the clutch
master cylinder and clutch master cylinder kit
as a set.
3. Check:
• Clutch master cylinder reservoir
Cracks/damage → Replace.
• Clutch master cylinder reservoir diaphragm
Damage/wear → Replace.
4. Check:
• Clutch hose
Cracks/damage/wear → Replace.
EAS25300
ASSEMBLING THE CLUTCH MASTER
CYLINDER
EW3P61015
WARNING
• Before installation, all internal clutch com-
ponents must be cleaned and lubricated
with clean or new clutch fluid.
• Never use solvents on internal clutch com-
ponents.
Recommended fluid
DOT 4
EAS25310
INSTALLING THE CLUTCH MASTER
CYLINDER (FJR13A)
1. Install:
• Clutch master cylinder "1"
• Clutch master cylinder holder "2"
EW3P61016
WARNING
• Install the clutch lever holder with the "UP"
mark facing up.
• Align the end of the clutch lever holder with
the punch mark "a" on the left handlebar.
Every two years and
whenever the clutch
is disassembled
5-61
• First, tighten the upper bolt, then the lower
bolt.
2. Install:
• Copper washers "1"
• Clutch hose "2"
• Clutch hose union bolt "3"
Clutch hose union bolt
30 Nm (3.0 m·kg, 22 ft·lb)
EW3P61017
WARNING
Proper clutch hose routing is essential to in-
sure safe vehicle operation. Refer to "CABLE
ROUTING (FJR13A)" on page 2-47.
EC3P61034
CAUTION:
When installing the clutch hose onto the
clutch master cylinder, make sure the clutch
pipe touches the projection "a" as shown.
NOTE:
Turn the handlebars to the left and to the right to
make sure the clutch hose does not touch other
parts (e.g., wire harness, cables, leads). Correct
if necessary.
3. Fill:
• Clutch master cylinder reservoir
(with the specified amount of the recom-
mended clutch fluid)
Recommended fluid
DOT 4
CLUTCH
New

Advertisement

Table of Contents

Troubleshooting

loading

This manual is also suitable for:

Fjr13av(c)

Table of Contents