Replacing the optical-drive eject-
button board
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before working inside your
computer, follow the instructions in
computer. For more safety best practices, see the Regulatory
Compliance home page at www.dell.com/regulatory_compliance.
Procedure
1
Align and place the optical-drive eject-button board, along with the cable on
the chassis.
2
Replace the two screws (#6-32x6) that secure the optical-drive eject-button
board to the chassis.
3
Secure the optical-drive eject-button board cable to the chassis using the
securing clips.
4
Connect the optical-drive eject-button board cable to the I/O board.
Post-requisites
1
Replace the
2
Replace the
3
Replace the left and right side-panels. See
4
Replace the
front
bezel.
handle
bars.
stability
foot.
computer. After working inside your
After working inside your
"Replacing the side
panels".
151