Replacing The Handle Bars; Procedure; Post-Requisites - Alienware Area-51 R3 Threadripper Edition Service Manual

Replacing the handle bars

WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before working inside your
computer, follow the instructions in
computer. For more safety best practices, see the Regulatory
Compliance home page at www.dell.com/regulatory_compliance.

Procedure

1 Align and place the bottom-handle bar on the slot and snap the bottom-
handle bar to the chassis.
2 Replace the seven screws (#6-32x6.5) that secure the bottom-handle bar to
the left side of the chassis.
3 Replace the seven screws (#6-32x6.5) that secure the bottom-handle bar to
the right side of the chassis.
4 Align and place the front-handle bar on the slot and snap the front-handle
bar to the chassis.
5 Replace the seven screws (#6-32x6.5) that secure the front-handle bar to
the left side of the chassis.
6 Replace the seven screws (#6-32x6.5) that secure the front-handle bar to
the right side of the chassis.
7 Align and place the rear-handle bar on the slot and snap the rear-handle bar
to the chassis.
8 Replace the seven screws (#6-32x6.5) that secure the rear-handle bar to
the left side of the chassis.
9 Replace the seven screws (#6-32x6.5) that secure the rear-handle bar to
the right side of the chassis.

Post-requisites

1 Replace the left and right side-panels. See
2 Replace the stability foot.
computer. After working inside your
After working inside your
"Replacing the side panels".
141