Replacing The Antenna Cables; Procedure; Post-Requisites - Alienware Area-51 R3 Threadripper Edition Service Manual

Replacing the antenna cables

WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before working inside your
computer, follow the instructions in
computer. For more safety best practices, see the Regulatory
Compliance home page at www.dell.com/regulatory_compliance.

Procedure

1 Place the antenna cables in place and slide the antenna cables through the
slot on the chassis.
2 Replace the six screws (#6-32x6) that secure the antenna cables to the
chassis.
3 Adhere the tape that secures the antenna cables to the chassis.
4 Route the antenna cable through the slot on the chassis and then through
the routing guides on the chassis.
5 Route the gray antenna cable through the routing guide on the chassis.
6 Connect the antenna cables from the wireless card.

Post-requisites

1 Replace the
2 Replace the
3 Replace the
4 Replace the
5 Replace the
6 Replace the
7 Replace the
8 Replace the left and right side-panels. See
9 Replace the
rear bezel.
system board.
processor liquid-cooling
wireless card.
full-length graphics
memory modules.
handle bars.
stability foot.
computer. After working inside your
After working inside your
assembly.
cards.
"Replacing the side panels".
179