Replacing The Logo Board; Procedure; Post-Requisites - Alienware Area-51 R3 Threadripper Edition Service Manual

Replacing the logo board

WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before working inside your
computer, follow the instructions in
computer. For more safety best practices, see the Regulatory
Compliance home page at www.dell.com/regulatory_compliance.

Procedure

1 Align the screw holes on the logo board to the screw holes on the bracket
and slide the logo board in place.
2 Replace the six screws (#6-32x6) that secure the logo board to the bracket.
3 Slide the logo board inside the chassis.
4 Replace the screw (#6-32x6) that secures the logo board to the bracket.
5 Route and connect the respective to the logo board.

Post-requisites

1 Replace the left and right side-panels. See
2 Replace the
98
stability foot.
computer. After working inside your
After working inside your
"Replacing the side panels".