Replacing The Power-Button Board; Procedure; Post-Requisites - Alienware ALPHA Service Manual

Replacing the Power-Button
Board
WARNING: Before working inside your computer, read the
safety information that shipped with your computer and
follow the steps in
After working inside your computer, follow the instructions
in After Working Inside Your
practices, see the Regulatory Compliance home page at
dell.com/regulatory_compliance.

Procedure

1
Use the alignment posts on power-button board bracket to align the
power-button board into the slot on the power-button board bracket.
2
Snap the power-button board in place on the power-button board bracket.
3 Route the power-button board cable through the cable-routing hole on the
chassis.
4 Align and snap the power-button module into the slot on the front panel.
5
Connect the power-button board cable to the system board.
6 Turn over the chassis and route the antenna cable through the routing
guides on the power-button board module.

Post-requisites

1 Replace the top
2
Replace the base
Before Working Inside Your
cover.
cover.
Computer. For more safety best
Computer.
33