Set The Switches - Emerson Rosemount Reference Manual

Reference Manual
00809-0100-4021, Rev GC
2.2.2

Set the switches

HART
Without an LCD display
1.
2.
3.
4.
5.
With an LCD display
1.
2.
3.
4.
5.
6.
7.
8.
Installation
®
If the transmitter is installed in a loop, set the loop to manual mode and disconnect the
power.
Remove the housing cover on the electronics side of the transmitter. Do not remove
the transmitter cover in explosive atmospheres with a live circuit.
Set the switches to the desired position (see
Replace the transmitter cover. Both transmitter covers must be fully engaged to meet
explosion-proof requirements.
Apply power and set the loop to automatic mode.
If the transmitter is installed in a loop, set the loop to manual mode and disconnect the
power.
Remove the housing cover on the electronics side of the transmitter. Do not remove
the transmitter cover in explosive atmospheres with a live circuit.
Unscrew the LCD display screws and gently slide the meter straight off.
Set the switches to the desired position (see
Gently slide the LCD display back into place, taking extra precautions with the 10 pin
connection.
Replace and tighten the LCD display screws to secure the LCD display.
Replace the transmitter cover. Both transmitter covers must be fully engaged to meet
explosion-proof requirements.
Apply power and set the loop to automatic mode.
Section 2: Installation
Figure 2-2).
Figure 2-2).
April 2014
11