Emerson Rosemount Reference Manual page 72

Section 3: HART commissioning
April 2014
LCD display message
The LCD display on the transmitter will display a message WARN SNSR 2 FAIL. It will also continue
to display the output of your primary sensor:
After the sensor has been repaired or replaced, the LCD display warning message will clear and
display the output of the primary variable.
DeltaV message
Alarms will show up on the bottom toolbar, as shown below:
To view the alarm, simply click on the device on the toolbar. A Faceplate with further
information on the active alarms will appear. It will show an ADVISE Sensor Summary, a FAILED
Sensor 2 Open, and a MAINTENANCE Hot Backup Active.
Note
For all of these alarms to appear in DeltaV, all alarms in DeltaV must be configured to WARNING
status.
62
Reference Manual
00809-0100-4021, Rev GC
HART® commissioning