How To Select The Operating Mode - Furuno FMD-3200 Operator's Manual

2. OPERATIONAL OVERVIEW
2. To switch between the alphabet keyboard and symbols keyboard, click the [!$&]
key.
3. Click the input box.
4. Click appropriate keys and finally click the [Enter] key.
To erase the software keyboard, click the X button at the top right corner of the key-
board.
Alphanumeric data entry with the trackball module
The trackball module can also be used to enter alphanumeric data.
1. Put the cursor in the input box. Up and down arrows
appear at the right side of the box.
2. Enter data by one of the methods shown below.
• Spin the scrollwheel to set data. Upward to decrease the value; downward to
increase the value.
• Click
How to enter latitude and longitude data with the trackball module
The trackball module can also be used to enter latitude and longitude data.
1. Put the cursor in the input box. A selection cursor (light-
blue) appears.
2. Enter data by spinning the scrollwheel. Upward to de-
crease the value; downward to increase the value.
3. To switch coordinate between N and S and vice versa,
put the cursor at the right edge of the input box. Dual ar-
rows appear
4. Click to switch the coordinates. The method to switch E to W and vice versa is the
same.
2.2

How to Select the Operating Mode

Click the [Display Mode] button at the far left side of the Status
bar to select the operating mode, [ECDIS] or [CONNING].
[ECDIS] displays electronic charts. The conning display pro-
vides comprehensive navigation displays such as wind direc-
tion and rudder angle, in analog and digital formats. (Note that
this button is inoperative if the conning display is fed to anoth-
er monitor.) See section 21.1.
2-14
Alphabet keyboard
to increase the value;
Symbols keyboard
to decrease the value.
Selection cursor
[Display Mode] button