How To Select The Source For Main Picture; How To Select The Source For The Pip Window - Furuno MU-192HD Operator's Manual

2. Press the  or  key to adjust the brilliance (available range: 1 to 50, default: 50).
You can also adjust the brilliance by pressing the
Note 1: If the display unit is turned off with the brilliance set to minimum, the screen may not be
visible depending on lighting conditions. In this case, press the
the brilliance.
Note 2: When the display unit is used with a unit for FAR-2xx8 series radar, you can adjust the
brilliance from the FAR-2xx8 series. (see paragraph 3.6.1.)
3.4

How to Select the Source for Main Picture

Select the signal to display on the entire screen as follows:
1. Press the DISP key to show the DISP selection window.
The signal names are shown in the window as you customized at section 2.3.2.This window
disappears if there is no operation for five seconds.
2. Press the  or  key to select a signal.
You can also select the signal by pressing the DISP key continuously.
[RGB]: The signal from the RGB port is displayed.
[DVI]: The signal from the DVI port is displayed.
[HDMI]: The signal from the HDMI port is displayed.
[VIDEO]: The external video from the VIDEO port is displayed.
3. Press the  or  key to close the window.
The name of the selected signal appears at the right top corner for five seconds after the DISP
selection window disappears. If there is no signal, "NO SIGNAL" appears.
3.5

How to Select the Source for the PIP Window

Select the source for the PIP (picture-in-picture) window as follows. The PIP window is available
on the RGB, DVI and HDMI displays.
1. With the RGB, DVI or HDMI display shown, press the PIP key to show the PIP window. To
hide the PIP window, press the PIP key again.
RGB
DVI1
HDMI
VIDEO
DISP selection window (Default setting)
PIP window
/BRILL key repeatedly.
/BRILL key repeatedly to raise
26
3. OPERATION