How To Stop Recording; Operation On Remote Alarm Panel; Start Screen And Base Screen - Furuno VR-7000 Operator's Manual

1. OPERATION
1.2.2

How to stop recording

Recording is terminated only under the following conditions:
• During essential maintenance while the vessel is in port.
• When the vessel is laid-up.
To stop recording, open the DCU door with its key and turn off the BATTERY and AC
switches in that order. DO NOT turn off the system by the main breaker while the BAT-
TERY switch is on. If only the AC switch is turned off, the system operates on the bat-
teries. The system stops after recording the audio data only for two hours. When the
AC power is supplied to the DCU again, the batteries are charged. The BATTERY
BACKUP LED flashes while charging the batteries.
Note: After the power to the DCU is turned off, wait at least 10 seconds before reap-
plying the power. The DCU may not function correctly.
1.3

Operation on Remote Alarm Panel

1.3.1

Start screen and base screen

No power switch is provided on the Remote Alarm Panel; it is turned on and off by the
power switch on the DCU. After the boot program screen appears, the start screen ap-
pears followed by the base screen.
REMOTE ALARM PANEL
Note: When the DCU does not boot normally, it takes a maximum of 10 minutes to
display the base screen. The error message "Lost DCU" ("No DCU connection" for
Legacy mode) appears on the screen.
1-6
VR-7017
Start screen
VR-7000
VR-7017 VDR REMOTE ALARM PANEL
[MENU/ESC] : List [ENT] : - - -
Base screen for VR-7000
"Press MENU, then ENT to save recorded data."
VR-7000S
VR-7017 SVDR REMOTE ALARM PANEL
[MENU/ESC] : List [ENT] : - - -
Base screen for VR-7000S
▲ ▼ ◄ ►
/ / / : Brill
▲ ▼ ◄ ►
/ / / : Brill