Get - HP 6125XLG Command Reference Manual

-i interface-type interface-number: Specifies an output interface by its type and number. This parameter
can be used only when the FTP server address is a link local address and the specified output interface
has a link local address.
Usage guidelines
This command is only applicable to IPv6 networks.
If no parameters are specified, this command enters the FTP client view.
If the FTP server parameters are specified, you are prompted to enter the username and password for
logging in to the FTP server.
Examples
# Log in to the FTP server 2000::154.
<Sysname>ftp ipv6 2000::154
Press CTRL+C to abort.
Connected to 2000::154 (2000::154).
220 FTP service ready.
User (2000::154): root
331 Password required for root.
Password:
230 User logged in
Remote system type is HP

get

Use get to download a file from the FTP server and save the file.
Syntax
get remotefile [ localfile ]
Views
FTP client view
Predefined user roles
network-admin
Parameters
remotefile: Specifies the name of the file to be downloaded.
localfile: Specifies a name for the downloaded file.
Usage guidelines
You can perform this operation only after you log in to the FTP server.
To save the downloaded file to the working directory accessed by the ftp command, the localfile
argument must specify a file name such as a.cfg. If you do not provide the localfile argument, the
downloaded file uses its original name.
To save the downloaded file to some other directory, the localfile argument must specify the target
directory plus the file name such as flash:/subdirectory/a.cfg. Otherwise, the command fails to take
effect.
94