Interface M-Eth0; Ip Address - HP 6125XLG Command Reference Manual

Line aux0 is available.
Press ENTER to get started.

interface m-eth0

Use interface m-eth0 to enter management Ethernet port view.
Syntax
interface m-eth0
Views
System view
Usage guidelines
In management Ethernet port view, you can assign an IP address to the port and specify a gateway.
Examples
# Enter management Ethernet port view.
<boot> system-view
[boot] interface m-eth0
[boot-m-eth0]
Related commands
quit

ip address

Use ip address to assign an IPv4 address to the management Ethernet port.
Use undo ip address to restore the default.
Syntax
ip address ip-address { mask-length | mask }
undo ip address
Default
The management Ethernet port has no IPv4 address.
Views
Management Ethernet port view
Parameters
ip-address: Specifies an IPv4 address in dotted decimal notation.
mask-length: Specifies the length of the subnet mask, in the range of 0 to 31.
SDRAM fast selftest........................OK!
Flash fast selftest........................OK!
CPLD selftest..............................OK!
Switch chip selftest.......................OK!
PHY selftest...............................OK!
Please check leds....................FINISHED!
179