KEB COMBIVERT F4-C Applications Manual page 228

Initial Start-up
7.2 Initial Start-up
7.2.1 Switching on of
KEB COMBIVERT
© KEB Antriebstechnik, 1997
All Rights reserved
After all preparatory measures have been carried out the KEB COMBIVERT F4 can
be switched on.
The sequence of the switch-on procedure as shown below refers to supplied units
with factory setting. Because of the multitude of programs we cannot take into
consideration customer-specific adjustments.
Picture 7.2.1 Swtich on of KEB COMBIVERT
Switch on inverter
Display dark?
Is an error
message
displayed?
(E. xx)
Display "noP" ?
Switch control release
Kl. X1.19
Display "LS" ?
Press "ENTER" key
Display "CP. 1"
Name: Basis
KEB COMBIVERT F4-C
Start-up
1. Check mains voltage
1. Check system voltage!
2. Operator inserted correctly?
Yes
2. Operator inserted correctly?
3. Check connections of control
3. Check connection of control
card for short circuit!
card for short circuit
Yes
Look up cause and remedy in
Chapter 9 "Error Assistance"
Yes
Enable direction of rotation
terminal Kl. X1.10 or X1.11
Yes
Date Chapter
09.03.98
ANTRIEBSTECHNIK
Section Page
3
7 2 3
7