Mounting - GE 845 Instruction Manual

MECHANICAL INSTALLATION

Mounting

2–2
Figure 2-2: 845 Dimensions
The unit can be mounted two ways: standard panel mount or optional tab mounting, if
required.
• Standard panel mounting:
From the front of the panel, slide the empty case into the cutout. From the rear of the
panel, screw the case into the panel at the 8 screw positions (see figures in Standard
panel mount section).
• Optional tab mounting:
The "V" tabs are located on the sides of the case and appear as shown in the
following figure. Use needle nose pliers to bend the retaining "V" tabs outward to
about 90°. Use caution and do not bend and distort the wall of the enclosure adjacent
to the tabs. The relay can now be inserted and can be panel wired.
845 TRANSFORMER PROTECTION SYSTEM – INSTRUCTION MANUAL
CHAPTER 2: INSTALLATION