Software Interface; Enervista 8 Series Setup Software - GE 845 Instruction Manual

CHAPTER 3: INTERFACES

Software Interface

EnerVista 8 Series Setup Software

845 TRANSFORMER PROTECTION SYSTEM – INSTRUCTION MANUAL
2. Slide the label removal tool under the LED label as shown in the next image. Make sure
the bent tabs are pointing away from the relay. Move the tool inside until the tabs
enter the pocket.
3. Remove the tool with the LED label.
The following describes how to remove the user-programmable pushbutton labels from
the 845 front panel.
1. Slide the label tool under the user-programmable pushbutton label as shown in the
next image. Make sure the bent tab is pointing away from the relay.
2. Remove the tool and user-programmable pushbutton label as shown in image.
Although settings can be entered manually using the control panel keys, a PC can be used
to download setpoints through the communications port. The EnerVista 8 Series
Setup software is available from GE Multilin to make this as convenient as possible. With
EnerVista 8 Series Setup software running, it is possible to:
SOFTWARE INTERFACE
3–13