Table of Contents
Advertisement
CHAPTER 3: INTERFACES
Printing Setpoints
845 TRANSFORMER PROTECTION SYSTEM – INSTRUCTION MANUAL
6.
For example, if the firmware revision is J0J08AA120.SFD (Firmware Revision 1.20) and
the current setpoint file revision is 1.10, change the New File Version to "1.2x".
7.
Enter any special comments about the setpoint file in the "Description" field.
8.
Select the desired firmware version from the "New File Version" field.
9.
When complete, click OK to convert the setpoint file to the desired revision. See
Loading Setpoints from a File below, for instructions on loading this setpoint file into
the 845.
The software allows the user to print partial or complete lists of setpoints. Use the following
procedure to print a list of setpoints:
1.
Select a previously saved setpoints file in the File pane or establish communications
with a device.
2.
If printing from an online device, select the Online > Print Device Information menu
item. If printing from a previously saved setpoints file, select the Offline > Print
Settings File menu item.
SOFTWARE INTERFACE
3–25
- Quick Links:
- 845 Order Codes
- Protection
Hide quick links:
Advertisement
Table of Contents
