GE 845 Instruction Manual page 125

CHAPTER 4: SETPOINTS
NOTE:
845 TRANSFORMER PROTECTION SYSTEM – INSTRUCTION MANUAL
ENABLE PASSWORD COMPLEXITY
Range: Disabled, Enabled
Default: Disabled
This setting is available to provide the option of selecting between simple passwords and
complex ones. The following conditions apply:
– The setting is only available to Administrator
– By default password complexity is disabled
– When password complexity is enabled, it follows the rules defined in the
Password Complexity section.
SYSLOG IP ADDRESS
Range: 0.0.0.0 to 223.255.255.254
Default: 0.0.0.0
This is the IP address of the target Syslog server all security events are transmitted to.
SYSLOG PORT NUMBER
Range: 1 to 65535
Default: 514
This sets the UDP port number of the target Syslog server all security events are
transmitted to.
SETPOINT ACCESS
Range: Off, On, Digital Input
Default: Off
– The setting is only available to Administrator.
– The setpoint access setting may be assigned to a digital input.
– When the digital input is activated, the user gets Administrator access to the front
panel.
FACTORY SERVICE MODE
Range: Disabled, Enabled
Default: Disabled
– When the feature is enabled, the Factory role is accessible and the device may go
into factory service mode.
– The setting may be changed only by an Administrator.
– The default value is Disabled.
The factory role password may not be changed.
CHANGE PASSWORDS SETTINGS
– The two menu items: Change Administrator Password, and Change Operator
Password are available only to Administrator, which is the only role that has
permissions to change passwords for itself and the other local roles.
– Each password change menu has two settings: New Password and Confirm
Password.
– With password complexity enabled, each setting may take 6 to 20 alphanumeric
characters. With password complexity disabled, each setting takes 1 to 20
alphanumeric characters.
– If password complexity is enabled, its rules, as defined in the section Password
Complexity, must be obeyed.
– The default password is "0".
– The Observer does not have a password associated with it. So there is no need to
show it in the list of password changing roles.
DEVICE
4–21