Video Commands - Cisco TelePresence SX10 Reference Manual

Cisco TelePresence SX10

Introduction
xCommand UserManagement User Passphrase Set
Set a user passphrase for the specified user. You must be logged in as an administrator to set a
user passphrase.
Requires user role: ADMIN
USAGE:
xCommand UserManagement User Passphrase Set NewPassphrase: "NewPassphrase"
Username: "Username" YourPassphrase: "YourPassphrase"
where
NewPassphrase: String (0, 255)
Username: String (0, 127)
YourPassphrase: String (0, 255)
Cisco TelePresence SX10 API Reference Guide CE8.2, SEPTEMBER 2016.
D15333.07
About the API xConfiguration xCommand xCommand

Video commands

xCommand Video ActiveSpeakerPIP Set
Sets position for the active speakers PiP (picture in picture).
Requires user role: ADMIN, USER
USAGE:
xCommand Video ActiveSpeakerPIP Set Position:
where
Position: CenterLeft/CenterRight/LowerLeft/LowerRight/UpperCenter/UpperLeft/UpperRight
Select one of the predefined positions.
xCommand Video Input Source SetActiveConnector
Select which connector is active.
Requires user role: ADMIN, USER
USAGE:
xCommand Video Input Source SetActiveConnector [ConnectorId: ConnectorId]
where
ConnectorId: Integer (2..3)
The identifier (ID) of the connector. Connector [n] has ID n. Run the following API
command to find the ID: xStatus Video Input Connector. The connector ID is also printed
on the codec connector panel.
131
API Reference Guide
xStatus Appendices
Position
Copyright © 2016 Cisco Systems, Inc. All rights reserved.