Cisco TelePresence SX10 Reference Manual page 129

Cisco TelePresence SX10

Introduction
xCommand UserInterface Message TextLine Display
Display a text line on screen. Optionally you can place the text line at a specified location and
for a specified duration of time (in seconds).
NOTE: If Duration is not set, the command must be followed by xCommand Message TextLine
Clear.
Requires user role: ADMIN
USAGE:
xCommand UserInterface Message TextLine Display Text: "Text" [X: X] [Y: Y]
[Duration: Duration]
where
Text: String (0, 140)
Enter the text line to be displayed. The <p> and <br> HTML tags will result in line breaks
as normal; any other tags will appear as plain text.
X: Integer (1..10000)
Enter the X-coordinate (horizontal) on screen. X=0 is in the upper left corner.
Y: Integer (1..10000)
Enter the Y-coordinate (vertical) on screen. Y=0 is in the upper left corner.
Duration: Integer (0..3600)
Set how long (in seconds) the text line is to be displayed on the screen. If set to 0 (zero)
the text line is displayed until a xCommand Message TextLine Clear command has been
sent.
xCommand UserInterface OSD Key Click
Emulates a remote control key press, followed by a key release.
Requires user role: ADMIN
USAGE:
xCommand UserInterface OSD Key Click Key:
where
Key: 0/1/2/3/4/5/6/7/8/9/C/Call/Disconnect/Down/F1/F2/F3/F4/F5/Grab/Home/Layout/Left/
Mute/MuteMic/Ok/PhoneBook/Presentation/Right/Selfview/Square/SrcAux/SrcCamera/
SrcDocCam/SrcPc/SrcVcr/Star/Up/VolumeDown/VolumeUp/ZoomIn/ZoomOut/+/-
Define the remote key to press.
Cisco TelePresence SX10 API Reference Guide CE8.2, SEPTEMBER 2016.
D15333.07
About the API xConfiguration
Key
xCommand xCommand
xCommand UserInterface OSD Key Press
Emulates a remote control key press without releasing it. The Key Press command must be
followed
by a Key Release command to emulate releasing the key.
Requires user role: ADMIN
USAGE:
xCommand UserInterface OSD Key Press Key:
where
Key: 0/1/2/3/4/5/6/7/8/9/C/Call/Disconnect/Down/F1/F2/F3/F4/F5/Grab/Home/Layout/Left/
Mute/MuteMic/Ok/PhoneBook/Presentation/Right/Selfview/Square/SrcAux/SrcCamera/
SrcDocCam/SrcPc/SrcVcr/Star/Up/VolumeDown/VolumeUp/ZoomIn/ZoomOut/+/-
Define the remote key to press.
xCommand UserInterface OSD Key Release
Emulates a remote control key release. The Key Release command is issued after a Key Press
command.
Requires user role: ADMIN
USAGE:
xCommand UserInterface OSD Key Release Key:
where
Key: 0/1/2/3/4/5/6/7/8/9/C/Call/Disconnect/Down/F1/F2/F3/F4/F5/Grab/Home/Layout/Left/
Mute/MuteMic/Ok/PhoneBook/Presentation/Right/Selfview/Square/SrcAux/SrcCamera/
SrcDocCam/SrcPc/SrcVcr/Star/Up/VolumeDown/VolumeUp/ZoomIn/ZoomOut/+/-
Define the remote control key to release.
129
API Reference Guide
xStatus Appendices
Key
Key
Copyright © 2016 Cisco Systems, Inc. All rights reserved.