Cisco TelePresence SX10
Introduction
xConfiguration Conference FarEndControl Mode
Lets you decide if the remote side (far end) should be allowed to select your video sources and
control your local camera (pan, tilt, zoom).
Requires user role: ADMIN
Default value: On
USAGE:
xConfiguration Conference FarEndControl Mode:
where
Mode
: Off/On
Off: The far end is not allowed to select your video sources or to control your local
camera (pan, tilt, zoom).
On: Allows the far end to be able to select your video sources and control your local
camera (pan, tilt, zoom). You will still be able to control your camera and select your
video sources as normal.
xConfiguration Conference MaxReceiveCallRate
Define the maximum receive bit rate to be used when placing or receiving calls. Note that this
is the maximum bit rate for each individual call; use the Conference MaxTotalReceiveCallRate
setting to set the aggregated maximum for all simultaneous active calls.
Requires user role: ADMIN
Default value: 3072
USAGE:
xConfiguration Conference MaxReceiveCallRate:
where
MaxReceiveCallRate
: Integer (64..3072)
The maximum receive call rate (kbps).
Cisco TelePresence SX10 API Reference Guide CE8.2, SEPTEMBER 2016.
D15333.07
About the API
xConfiguration
xConfiguration
Mode
MaxReceiveCallRate
xCommand
xConfiguration Conference MaxTransmitCallRate
Define the maximum transmit bit rate to be used when placing or receiving calls. Note that this
is the maximum bit rate for each individual call; use the Conference MaxTotalTransmitCallRate
setting to set the aggregated maximum for all simultaneous active calls.
Requires user role: ADMIN
Default value: 3072
USAGE:
xConfiguration Conference MaxTransmitCallRate:
where
MaxTransmitCallRate
: Integer (64..3072)
The maximum transmitt call rate (kbps).
xConfiguration Conference MaxTotalReceiveCallRate
Define the maximum overall receive bit rate allowed. This product does not support multiple
simultaneous calls, so the total receive call rate will be the same as the receive bit rate for one
call (ref. Conference MaxReceiveCallRate setting).
Requires user role: ADMIN
Default value: 3072
USAGE:
xConfiguration Conference MaxTotalReceiveCallRate:
where
MaxTotalReceiveCallRate
: Integer (64..3072)
The maximum receive call rate (kbps).
54
API Reference Guide
xStatus
Appendices
MaxTransmitCallRate
MaxTotalReceiveCallRate
Copyright © 2016 Cisco Systems, Inc. All rights reserved.