Translating From Terminal Mode To Xml - Cisco TelePresence SX10 Reference Manual

Cisco TelePresence SX10

Introduction

Translating from terminal mode to XML

Translating commands
The XML commands maintain the same structure as the
terminal commands, but they use a parent-child relationship
to describe the hierarchy. You can see this structure in the
examples below.
Example 1: Setting up a call.
Terminal
xCommand Dial Number: "12345" Protocol: H323
XML
<Command>
<Dial command="True">
<Number>12345</Number>
<Protocol>H323</Protocol>
</Dial>
</Command>
Example 2: Assigning video layout to a call.
Terminal
xCommand Video Layout AssignCall CallId: 2
LayoutId: 1
XML
<Command>
<Video>
<Layout>
<AssignCall command="True">
<CallId>2</CallId>
<LayoutId>1</LayoutId>
</AssignCall>
</Layout>
</Video>
</Command>
Cisco TelePresence SX10 API Reference Guide CE8.2, SEPTEMBER 2016.
D15333.07
About the API About the API xConfiguration
Translating configurations
Translating from xConfiguration to XML is similar to commands,
but with the addition of a special attribute item="NN" for
specifying the index in arrays.
Example: Configuring the input source type for video input
connector 2.
Terminal
xConfiguration Video Input Connector 2
InputSourceType: camera
XML
<Configuration>
<Video>
<Input>
<Connector item="2">
</Connector>
</Input>
</Video>
</Configuration>
xCommand
<InputSourceType>camera</InputSourceType>
41
API Reference Guide
xStatus Appendices
Copyright © 2016 Cisco Systems, Inc. All rights reserved.