Xconfiguration Conference Autoanswer Delay; Xconfiguration Conference Defaultcall Rate; Xconfiguration Conference Donotdisturb Defaulttimeout; Xconfiguration Conference Encryption Mode - Cisco TelePresence SX10 Reference Manual

Cisco TelePresence SX10

Introduction

xConfiguration Conference AutoAnswer Delay

Define how long (in seconds) an incoming call has to wait before it is answered automatically by
the system. Requires that AutoAnswer Mode is switched on.
Requires user role: ADMIN
Default value: 0
USAGE:
xConfiguration Conference AutoAnswer Delay:
where
Delay
: Integer (0..50)
The auto answer delay (seconds).

xConfiguration Conference DefaultCall Rate

Define the Default Call Rate to be used when placing calls from the system.
Requires user role: ADMIN
Default value: 3072
USAGE:
xConfiguration Conference DefaultCall Rate:
where
Rate
: Integer (64..3072)
The default call rate (kbps).
Cisco TelePresence SX10 API Reference Guide CE8.2, SEPTEMBER 2016.
D15333.07
About the API xConfiguration xConfiguration
Delay
Rate
xCommand

xConfiguration Conference DoNotDisturb DefaultTimeout

This setting determines the default duration of a Do Not Disturb session, i.e. the period when
incoming calls are rejected and registered as missed calls. The session can be terminated
earlier by using the user interface. The default value is 60 minutes.
Requires user role: ADMIN
Default value: 60
USAGE:
xConfiguration Conference DoNotDisturb DefaultTimeout:
where
DefaultTimeout
: Integer (1..1440)
The number of minutes (maximum 1440 minutes = 24 hours) before the Do Not Disturb
session times out automatically.

xConfiguration Conference Encryption Mode

Define the conference encryption mode. A padlock with the text "Encryption On" or
"Encryption Off" displays on screen for a few seconds when the conference starts.
NOTE: If the Encryption Option Key is not installed on the video system, the encryption mode is
always Off.
Requires user role: ADMIN
Default value: BestEffort
USAGE:
xConfiguration Conference Encryption Mode:
where
Mode
: Off/On/BestEffort
Off: The system will not use encryption.
On: The system will only allow calls that are encrypted.
BestEffort: The system will use encryption whenever possible.
> In Point to point calls: If the far end system supports encryption (AES-128), the call will
be encrypted. If not, the call will proceed without encryption.
> In MultiSite calls: In order to have encrypted MultiSite conferences, all sites must
support encryption. If not, the conference will be unencrypted.
53
API Reference Guide
xStatus Appendices
DefaultTimeout
Mode
Copyright © 2016 Cisco Systems, Inc. All rights reserved.