Mitsubishi Electric Q68AD-G User Manual page 229

7
ONLINE MODULE CHANGE
(3) Mounting of new module
(4) Operation check
7.3.6 When user range setting is used and initial setting was made with sequence program (other system is
(a) Mount a new module to the same slot and install the connector.
(b) After mounting the module, click the [Execution] button and make sure that the
"RUN" LED is lit. Module ready (X0) remains OFF.
(a) To make an operation check, click the [Cancel] button to cancel control
resumption.
(b) Click the [OK] button to leave the "Online module change" mode.
7.3 Online Module Change Procedure
1
2
3
4
5
6
7
8
7
- 34