Mitsubishi Electric Q68AD-G User Manual page 188

6
PROGRAMMING
(4) List of devices
D1(W1)
D2(W2)
D3(W3)
D6,D7(W6,W7)
D8(W8)
D9(W9)
D10
M12,M13
M34,M35
M50
X20
X21
X22
X23
Y30 to Y3B
X120
X129
X12C
X12E
X12F
Y129
Y12F
6.5 For Use in Remote I/O Network (Q66AD-DG)
6
- 31
(c) CH2 uses the warning output setting (process alarm) (Refer to Section 3.2.4 (1).)
• Process alarm lower lower limit value: 1000
• Process alarm lower upper limit value: 1500
• Process alarm upper lower limit value: 6000
• Process alarm upper upper limit value: 7000
(d) CH3 uses the warning output setting (rate alarm) (Refer to Section 3.2.4 (2).)
• Rate alarm warning detection period : 50ms
• Rate alarm upper limit value: 0.3%
• Rate alarm upper limit value: 0.1%
(e) In case of a write error, an error code is indicated in BCD format.
The error code is reset after the error cause is resolved.
Device
CH1 Digital output value
CH2 Digital output value
CH3 Digital output value
*1
Warning output flag
*1
Input signal error detection flag
*1
Error code
A/D conversion completed flag
CH2 Warning output flag (Process alarm)
CH3 Warning output flag (Rate alarm)
CH1 Input signal error detection flag
Initialization request signal
Digital output value read command input sinal
Input signal error detection reset signal
Error reset signal
Error code display (BCD 3 digits)
Module ready
Operating condition setting completed flag
Input signal error detection signal
A/D conversion completed flag
Error flag
Operating condition setting request
Error clear request
*1:Devices used for the auto refresh function of GX Configurator-AD.
For details on the MELSECNET/H remote I/O network, refer to the Q Correspond-
ing MELSECNET/H Network System Reference Manual (Remote I/O Network).
Function
QX10 (X20 to X2F)
QY10 (Y30 to Y3F)
Q66AD-DG
(X/Y120 to X/Y12F)