Mitsubishi Electric Q68AD-G User Manual page 224

7
ONLINE MODULE CHANGE
7.3 Online Module Change Procedure
7
- 29
7.3.5 When user range setting is used and initial setting was made with sequence program (other system is
(c) Click the [Close] button to close the System monitor window.
(d) Enable the conversion of the channel to be used in A/D conversion enable/disable
setting (Un\G0). Monitor CH
if the conversion is processed normally.
(e) Since the new module is in a default status, it must be initialized by a sequence
program after control resumption.
Before performing initialization, check whether the contents of the initialization
program are correct or not.
1) Normal system configuration
The sequence program should perform initialization on the leading edge of
Module READY (X9) of the A/D converter module.
When control resumption is executed, Module READY (X0) turns ON and
initialization is performed. (If the sequence program performs initialization only
one scan after RUN, initialization is not performed.)
2) When used on remote I/O networ
Insert a user device that will execute initialization at any timing (initialization
request signal) into the sequence program. After control resumption, turn ON
the initialization request signal to perform initialization. (If the sequence
program performs initialization only one scan after a data link start of the
remote I/O network, initialization is not performed.)
digital output values (Un\G11 to Un\G18) to check