4.3.2 Part identification and setting of Power Supply Module
The names and descriptions of each of the parts of the power supply modules are
(1) Names and description of parts of the A61P, A61PEU module
Module fixing hook
Hook for fixing the module to the base unit.
LED for indicating 5 VDC power.
Power fuse, fuse holder
4 A cartridge fuse for AC input power is secured by the fuse
Spare fuse for power supply
Spare fuse for power supply, mounted on rear side of the
For details, see below. (Located under the terminal cover)
Cover for protection of terminal block. Remove during wiring.
Re-install after wiring.
Module fixing screw mounting hole
Allows the module to be secured with a screw in addition to
the module fixing hook. (For M4 screw)
Power input terminals
Power input terminals to which AC power of 100 VAC or 200
Applied voltage select terminals
Terminals for selecting applied voltage. Use 100 VAC or 200
VAC as described below. When 100 VAC is input, connect
together the "SHORT AC100V" terminals with the jumper
provided. When 200 VAC is input, connect together the
"SHORT AC200V" terminals with the jumper provided.
Grounding of power filter. Has half the input potential.
Connection terminal connected to the shielding pattern on
printed circuit board.
M4 × 0.7 × 6