Download  Print this page

Error Codes - Mitsubishi Electric MELSEC A Series User Manual

Hide thumbs

Advertisement

6. ERROR CODES

If an error occurs in the RUN mode, an error display or error code (including a step
number) is stored in the special register by the self-diagnostic function. The error
code reading procedure and the causes of and corrective actions for errors are
shown below.
Section 6.1
Error Code List for AnNCPU (Table 6.1)
Section 6.2
Error Code List for AnACPU (Table 6.2)
Section 6.3
Error Code List for AnUCPU (Table 6.3)
Errors should be cleared by taking appropriate action.
6.1 Error Code List for AnNCPU
This section gives the error descriptions, possible causes, and corrective action for
AnNCPU error codes and error messages.
Error
Error
Code
Message
(D9008)
"INSTRCT.
10
CODE ERR"
(Checked at
the execution
of
instruction)
"PARAMETE
11
R ERROR"
(Checked at
power-on,
STOP →
RUN, and
PAUSE →
RUN)
Table 6.1 Error Code List for AnNCPU
CPU
Error and Cause
States
Stop
Instruction code, which
cannot be decoded by CPU,
is included in the program.
(1) EP-ROM or memory
cassette, which cannot
be decoded, has been
loaded.
(2) Since the memory
contents have changed
for some reason,
instruction code, which
cannot be decoded, has
been included.
Stop
(1) Capacity larger than the
memory capacity of
CPU module has been
set with the peripheral
equipment and then
write to CPU module
has been performed.
(2) The contents of
parameters of CPU
memory have changed
due to noise or the
improper loading of
memory.
(3) RAM is not loaded to the
A1 or A1NCPU.
(1) Read the error step by
(2) In the case of EP-ROM
(1) Check the memory
(2) Check the loading of
(3) Install the RAM and
83
Corrective Action
use of a peripheral
equipment and correct
the program at that step.
or memory cassette,
rewrite the contents or
replace with an EP-ROM
or memory cassette
which stores correct
contents.
capacity of CPU with the
memory capacity set by
peripheral equipment
and re-set incorrect
area.
CPU memory and load it
correctly. Read the
parameter contents of
CPU memory, check
and correct the
contents, and write them
to CPU again.
write parameter
contents from a
peripheral device.

Advertisement

Table of Contents

   Also See for Mitsubishi Electric MELSEC A Series

Comments to this Manuals

Symbols: 0
Latest comments: