Follow the procedure step by step to correctly diagnose the problem. Take particular care with the
checks highlighted by circled numbers, which are described in detail below:
Place the tester probes across pins 1-2 of the connector CN2 on the brake board and exercise
(1)
at a speed of 60 RPM. You should measure a Vdc which increases according to the exercise
level.
As for step (1) but across the two fast-on at the input of the brake.
(2)
As for step (1) but with everything reconnected, and across the brake winding.
(3)
If you replace Display board/Brake board, check that its SW version is updated, otherwise
install the last version.
Pagina 6.28
SYNCHRO EXCITE Class & Trend: Service & maintenance manual - rev. 2.0