Figure 7.11-7
Figure 7.11-8
Pagina 7.28
SYNCHRO EXCITE Class & Trend: Service & maintenance manual - rev. 2.0
11. Back off the two screws i using a medium
Phillips screwdriver, while supporting the
lever assembly.
12. Remove the entire lever assembly from the
machine.
13. It is now possible to disassemble the various
levers and handles, backing off the ring nuts
(l) and (m) with a 20mm and 15mm ring nut
spanner respectively, if necessary holding the
pins in place with an 8mm hexagonal
wrench.
To reassemble the lever, carry out the above
ATTENTION: During reassembly, lock
down the rings (l) using a torque wrench
setting of 70 Nm.
ATTENTION: During reassembly, lock
down the ring (m) using a torque wrench
setting of 50 Nm.
steps in reverse order.