Technogym Synchro Excite 500SP Service Maintenance Manual page 130

Figure 7.14-8
Figure 7.14-9
Figure 7.14-10
Pagina 7.36
SYNCHRO EXCITE Class & Trend: Service & maintenance manual - rev. 2.0
To disassemble the stator:
1. Back off the three screws (g) using a 4mm
hexagonal wrench and remove the stator.
To disassemble the copper disk:
1. Back off the 6 screws (h) using a 4mm
hexagonal wrench.
To disassemble the plastic pulley:
1. Back off the screw (i), using a 5mm
hexagonal wrench, and remove the washer
(l).
2. Remove the crank (m) using an extractor
tool.
It continues at page 7.36 of this procedure.
WARNING:
Take particular care with the
copper disk, as it can bends easily.
ATTENTION: During reassembly, lock
down the screws (h) using a torque
wrench setting of 6 Nm.
ATTENTION: During reassembly, lock
down the screw "i" using a torque wrench
setting of 30-Nm, and applying a drop of
Loctite red thread compound.
Continued on following page
→