Appendix; Updating The Sw - Technogym Synchro Excite 500SP Service Maintenance Manual

SYNCHRO EXCITE Class & Trend: Service & maintenance manual - rev. 2.0

12. APPENDIX

12.1. UPDATING THE SW

To update the machine SW it is necessary to change the contents of the FLASH EPROM on the 386
or ARM board by means of an external PC connected to the CSAFE port on the machine, situated
on the lower part of the display panel.
The PC can only update the FLASH EPROM during machine power up, before the self-test
sequence begins.
After the Display SW update it is necessary to restore all the parameters to the default values
following the detailed instructions provided in paragraph: 9.2.13. "Resetting parameters to
default values".
After the lower electronic SW update it is necessary to restore all the parameters to the default
values following the detailed instructions provided in paragraph: 9.5.1.3 "Default Setting".
Page 12.1