Brake Winding Disassembly - Technogym Synchro Excite 500SP Service Maintenance Manual

SYNCHRO EXCITE Class & Trend: Service & maintenance manual - rev. 2.0

7.12. BRAKE WINDING DISASSEMBLY

Figure 7.12-1
Figure 7.12-2
Carry out the operations described in 7.7.
"Guards" for removing the rear guards.
1. Unplug the two Faston connectors (a) from
the winding.
2. Unplug the connector circled in the figure at
left.
3. Back off the 2 screws (b) using an 8mm
hexagonal wrench, supporting the entire
brake winding group (c), to avoid damaging
the copper disk.
4. Remove the brake winding assembly
To reassemble the brake winding, carry out the
above steps in reverse order.
ATTENTION: After completing the
reassembly, adjust the position of the
winding group as described in paragraph
8.3. "Brake winding position".
Page 7.29